It is used while adjusting for the optimum quality of image print.

Adjust print quality acoording to the following procedure.

•	This printer was adjusted at the factory shipment so that it obtains the optimum printing quality. Adjust the quality when the print quality is changed after the installation environment or the media is changed.

1	Turn ON the printer and load equal to or bigger than A3 size of roll media. 3.4.2 Loading roll media

2	Confirm that the printer functions normally.

Press the [Menu] key on the operation panel.

•	The operation panel displays "Menu 1: Setup>".
•	Shift to the Setup menu display.

Press the [–] key on the operation panel twice.

•	The operation panel displays "Menu 3: Adjust. Print>".

Press the [>] key on the operation panel.

•	The operation panel displays "Adj.1: Confirm".
•	The display enters the Adjust Print menu.

Press the [Enter] key on the operation panel.

•	A confirmation pattern for quality adjustment is printed.

•	After the confirmation pattern is printed, the operation panel displays "Adj.1: Confirm".

Confirm that the confirmation pattern printing result is as follows.

a.	When the printing result is : You do not need perform Alignment.

b.	When the printing result is : You need to perform Alignment. Proceed to step 8.

Press the [+] or [–] key on the operation panel to select "Adj.4: Bi-D Quality".

Press the [Enter] key on the operation panel.

•	Start "Bi-D Quality" pattern printing.

Check the "Bi-D Quality" pattern printing and select the number corresponding to the lines that are most closely aligned.
"4" is selected in the next printing sample.

d.	Press the [+] key or [–] key to enter the number that you selected in step c.

Press the [Enter] key on the operation panel.

•	The set value for "Bi-D Quality" is registered.

•	Alignment ends.